Dodge Journey: Lamps Lighting - Exterior
Dodge Journey Service & Repair Manual / Accessories and Equipment / Lamps Lighting - Exterior
- Description
- Operation
- Diagnosis and Testing
- Standard procedure
- Cam, turn signal cancel
- Lamp, center high mounted stop
- Lamp, fog, front
- Lamp, fog, rear export
- Lamp, license plate
- Lamp, side repeater, export
- Lamp, tail stop turn
- Motor, headlamp leveling, export
- Relay, trailer tow
- Switch, backup lamp
- Switch, hazard warning
- Switch, headlamp leveling, export
- Switch, multifunction, left
- Switch, parking brake
- Switch, stop lamp
- Unit, front lamp
- Wiring, trailer tow
Pod, switch
DESCRIPTION
Fig. 10: Accessory Switch Bank Module
The Accessory Switch Bank Module (ASBM) is located in the center stack area
of the instrument panel just
below the heater and air conditioner d ...
Description
Fig. 1: Exterior Lighting System
The exterior lighting system for this vehicle includes the following exterior
lamp units:
Center High Mounted Stop Lamp (3) - A standard equipment Center High ...
See also:
Removal
LEFT-HAND-DRIVE
1. Disconnect and isolate the battery negative cable from its post on the
battery.
2. If equipped, remove the silencer pad below the steering column opening cover.
Fig. 132: S ...
TIRE PRESSURE MONITOR SYSTEM (TPMS)
The Tire Pressure Monitor System (TPMS) will warn the
driver of a low tire pressure based on the vehicle recommended
cold placard pressure.
The tire pressure will vary with temperature by about
1 ...
Installation
Fig. 51: Front Hub And Bearing Mounting
1. If required, install the hub and bearing (1) by sliding it into the
knuckle.
2. If installing hub and bearing, install the four bolts (2) fastening t ...
