ROOF LUGGAGE RACK — IF EQUIPPED

The roof rack cross rails and side rails are designed to carry cargo weight. The load must not exceed 150 lbs (68 kg), and it should be distributed uniformly over the cross rails. In addition, the ...

INSTRUMENT PANEL FEATURES

INSTRUMENT PANEL FEATURES 1 — Side Window Demist Outlet. 5 — Hazard Switch. 9 — Climate Control. 2 — Air Outlet. 6 — Switch Bank. 10 — Radio. 3 — Instrument Cluster. 7 — Beve ...

See also:

Removal
Fig. 35: Removing/Installing Halfshaft Nut NOTE: Rear suspension and drivetrain design require this procedure to be performed on a "drive-on" hoist, as the front and rear suspensi ...

Lamp, center high mounted stop
REMOVAL Fig. 5: Center High Mounted Stop Lamp 1. Disconnect and isolate the battery negative cable. 2. Remove the two screws (4) that secure the Center High Mounted Stop Lamp (CHMSL) (3) to t ...

Standard Procedure
MASTER CYLINDER BLEEDING 1. Clamp the master cylinder in a vise with soft-jaw caps. Fig. 88: BLEEDING MASTER CYLINDER WITH ABS 2. Thread a Bleeder Tube (2), Special Tool 8358-1, into the primary ...