Dodge Journey: Transmission

Toe
Fig. 115: Steering Wheel Holding Tool 1. Center the steering wheel and lock it in place using a steering wheel clamp. NOTE: When setting toe, make sure to set rear toe to the preferred spe ...

See also:

Standard procedure
FRONT LAMP AIMING VEHICLE PREPARATION FOR LAMP ALIGNMENT 1. Check for and correct any burnt out bulbs. 2. If the vehicle is equipped with headlamp leveling, be certain that the headlamp levelin ...

Removal
LEFT-HAND-DRIVE 1. Disconnect and isolate the battery negative cable from its post on the battery. 2. If equipped, remove the silencer pad below the steering column opening cover. Fig. 132: S ...

Seal, axle drive shaft
REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...

0.0143