Dodge Journey: STARTING AND OPERATING
Dodge Journey Owners Manual / STARTING AND OPERATING
- STARTING PROCEDURES
- ENGINE BLOCK HEATER — IF EQUIPPED
- AUTOMATIC TRANSMISSION
- AUTOSTICK — IF EQUIPPED
- ALL WHEEL DRIVE (AWD) — IF EQUIPPED
- DRIVING ON SLIPPERY SURFACES
- DRIVING THROUGH WATER
- POWER STEERING
- PARKING BRAKE
- BRAKE SYSTEM
- ELECTRONIC BRAKE CONTROL SYSTEM
- TIRE SAFETY INFORMATION
- TIRES — GENERAL INFORMATION
- TIRE CHAINS
- SNOW TIRES
- TIRE ROTATION RECOMMENDATIONS
- TIRE PRESSURE MONITOR SYSTEM (TPMS)
- FUEL REQUIREMENTS
- ADDING FUEL
- VEHICLE LOADING
- TRAILER TOWING
- RECREATIONAL TOWING (BEHIND MOTORHOME, ETC.)
CLIMATE CONTROLS
The Climate Control System allows you to regulate the
temperature, amount, and direction of air circulating
throughout the vehicle. The controls are located in the
center stack of the instrument pa ...
STARTING PROCEDURES
Before starting your vehicle, adjust your seat, adjust the
inside and outside mirrors, fasten your seat belt, and if
present, instruct all other occupants to buckle their seat
belts.
WARNING:
Nev ...
See also:
Flexplate
Removal
Fig. 198: Flex Plate
1. Remove transmission.
2. Remove flex plate attaching bolts (2).
3. Remove backing plate (3) and flex plate (1).
Installation
Fig. 199: FLEX PLATE
1. Posit ...
Removal, Installation
REMOVAL
Fig. 54: Removing /Installing Propeller Shaft
CAUTION: Propeller shaft removal is a two-man operation. Never
allow propeller shaft
to hang from the center bearing, or while o ...
Removal
Fig. 2: Engine Cover
Remove the engine cover.
1. Disconnect battery negative cable.
2. Remove air inlet tube (2) and air cleaner assembly (4).
Fig. 3: Bleeder At Slave Cylinder
3. Remove ...
