Lamp, side repeater, export

REMOVAL BULB NOTE: Side repeater lamps are used only on vehicles manufactured for certain export markets where they are required. Fig. 20: Remove/Install Repeater Lamp Bulb 1. Disconne ...

Removal

BULB Each rear lamp unit for this vehicle consists of two pieces. An outer rear lamp unit that is secured at the rear of each quarter panel includes bulbs for the park (or tail) lamps, the brake ( ...

See also:

RECREATIONAL TOWING (BEHIND MOTORHOME, ETC.)
TOWING THIS VEHICLE BEHIND ANOTHER VEHICLE (Flat Towing With All Four Wheels On The Ground) Recreational towing for this vehicle is not recommended. NOTE: If the vehicle requires towing, make sure ...

Seal, axle drive shaft
REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...

Cover, structural dust
Removal Fig. 172: Belly Pan 1. Raise and secure the vehicle on a hoist. 2. Remove the belly pan (2), if equipped. Fig. 173: Front Engine Mount Through Bolt 3. Remove the fore/aft crossmemb ...