Body, air cleaner

REMOVAL 1. Disconnect negative battery cable. Fig. 87: Inlet Air Temperature Sensor Electrical Connector 2. Disconnect inlet air temperature sensor electrical connector (3). 3. Disconnect fres ...

Description, Diagnosis and Testing

DESCRIPTION Fig. 91: Cylinder Head, Valves & Springs - VALVE KEEPER - SPRING RETAINER - VALVE KEEPER - VALVE SPRING-EXHAUST - SPRING RETAINER - VALVE STEM SEAL - VALVE-EXHAUST ...

See also:

Installation
Fig. 51: Front Hub And Bearing Mounting 1. If required, install the hub and bearing (1) by sliding it into the knuckle. 2. If installing hub and bearing, install the four bolts (2) fastening t ...

Installation
2.4L Fig. 7: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Install ignition coil capacitor (2) and bolt (1), tighten bolt to 10 N.m (88.5 ft. lbs.). 2. Connect electrical connect ...

Description, Operation
DESCRIPTION Fig. 29: Removing/Installing ECM - 2.0L Diesel The ECM (3) is located in the left side of engine compartment attached to the left inner fender below the air filter housing. OPERAT ...