Dodge Journey: Seal(s), valve guide
REMOVAL
Fig. 139: Valve Stem Seal-Removal/Installation
- - VALVE SEAL TOOL
- - VALVE STEM
1. Remove valve spring.
2. Remove valve stem seal by using a valve seal tool.
INSTALLATION
Fig. 140: Valve Stem Seal-Removal/Installation
- - VALVE SEAL TOOL
- - VALVE STEM
1. The valve stem seal/valve spring seat should be pushed firmly and squarely over the valve guide using the valve stem as guide. Do Not Force seal against top of guide.
2. Install valve spring.
Rocker arm, valve
DESCRIPTION
Fig. 133: Rocker Arm
- LASH ADJUSTER POCKET
- OIL SQUIRT HOLE
- ROLLER
The rocker arms are composed of steel stamping with an integral roller
bearing. The rocker arms incor ...
Spring(s), valve
Description
The valve springs are made from high strength, chrome-silicon steel. The
springs are common for intake and
exhaust applications. The valve spring seat is integral with the valve stem
...
See also:
ELECTRICAL POWER OUTLETS
There are two fused 12 Volt (13 Amp) power outlets
located in the center console below the radio. The power
outlet on the top has power available when the ignition
switch in the ON or ACC position. ...
Crankshaft
Description
The crankshaft is constructed of a forged micro alloy steel. The six throw,
nine counterweight crankshaft is
supported by four select fit main bearings with the number three serving as ...
Assembly
Fig. 239: Output Shaft #2 & Needle Bearing
1. Install the reverse needle bearing (1) onto the output shaft # 2 (2).
Fig. 240: Synchronizer
NOTE: Pay attention to the direction when inser ...
