Cleaning, Inspection

CLEANING Drain cooling system and refill with clean water. Refer to drain and fill procedures in this service information . Run engine with radiator cap installed until upper radiator hose is ho ...

Belt, serpentine

Description Fig. 15: ACCESSORY DRIVE BELT - WORLD ENGINE - POWER STEERING PUMP - ACCESSORY DRIVE BELT - GENERATOR - CRANKSHAFT PULLEY - LOWER IDLER PULLEY - CRANKSHAFT PULLEY - WATE ...

See also:

Installation
2.4L FRONT Fig. 38: Removing/Installing Camshaft Position Sensor CAUTION: Install camshaft position (CMP) sensor utilizing twisting motion. Make sure CMP sensor is fully seated. Do n ...

Description
The base brake system consists of the following components: Brake pedal Power brake booster Master cylinder Brake tubes and hoses Disc brakes (four-wheel) Brake lamp switch Brake fluid ...

Hydraulic pressure tests
Fig. 4: Identifying Transmission Electrical Connectors NOTE: Before preforming the hydraulic pressure tests be certain to disconnect the Variable Line Pressure (VLP) electrical connector (2 ...