Ensioner, belt

Removal 2.4L ENGINE Fig. 36: ACCESSORY DRIVE BELT - WORLD ENGINE - POWER STEERING PUMP - ACCESSORY DRIVE BELT - GENERATOR - CRANKSHAFT PULLEY - LOWER IDLER PULLEY - CRANKSHAFT PULLEY ...

Bottle, coolant recovery

Description NON-PRESSURE Fig. 52: NON-PRESSURE COOLANT RECOVERY CONTAINER - COOLANT RECOVERY CONTAINER - OVERFLOW HOSE - RADIATOR PRESSURE CAP The coolant recovery system used on 2.4L e ...

See also:

Horn
REMOVAL Fig. 1: Removing / Installing Horns 1. Disconnect and isolate the negative battery cable. 2. Remove the push pin type retainers along the top of the grille assembly and position the g ...

Switch, evaporative emissions system monitor
Operation Fig. 29: Evaporative Emissions System Monitor Switch - Intake Manifold - Throttle Body - Purge Solenoid - Filter - ESIM - Vapor Canister - Control Valve - Fuel Tank - ...

Installation
NOTE: Before stabilizer bar installation, inspect the cushions and links for excessive wear, cracks, damage and distortion. Replace any pieces failing inspection. NOTE: Before installing the ...