Ensioner, belt

Removal 2.4L ENGINE Fig. 36: ACCESSORY DRIVE BELT - WORLD ENGINE - POWER STEERING PUMP - ACCESSORY DRIVE BELT - GENERATOR - CRANKSHAFT PULLEY - LOWER IDLER PULLEY - CRANKSHAFT PULLEY ...

Bottle, coolant recovery

Description NON-PRESSURE Fig. 52: NON-PRESSURE COOLANT RECOVERY CONTAINER - COOLANT RECOVERY CONTAINER - OVERFLOW HOSE - RADIATOR PRESSURE CAP The coolant recovery system used on 2.4L e ...

See also:

Description
Fig. 1: Front Suspension Components This vehicle has a gas pressurized MacPherson strut type front suspension design. Each side of the front suspension consists of these major components: ...

Removal
1. Raise and support the vehicle. NOTE: Perform 2 through 5 on each side of the vehicle to complete pad set removal. Fig. 117: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts ...

Installation
Fig. 137: Rear Mount Bracket 1. If transmission brackets were removed or transmission was replaced install the rear mount bracket and tighten (1) to 100 N.m (74 ft. lbs.). Fig. 138: Front Mou ...