Crossmember, rear suspension

REMOVAL 1. Raise and support the vehicle. Fig. 52: Tire And Wheel Mounting 2. On each side of the vehicle, remove the wheel mounting nuts (3), then the front tire and wheel assembly (1). Fi ...

Description, Operation

DESCRIPTION CAUTION: Grid lines can be damaged or scraped off with sharp instruments. Care should be taken in cleaning glass or removing foreign materials, decals or stickers. Normal glass ...

See also:

Description, Operation, Diagnosis and Testing
DESCRIPTION The lubrication system is a full-flow filtration, pressure feed type. The oil pump body is mounted to the engine block. The pump inner rotor is driven by the crankshaft. A structural w ...

Assembly
Fig. 214: First Gear Needle Bearing & Output Shaft NOTE: Use ATF on all parts that are to be assembled in this procedure. 1. Install the first and first gear needle bearing (2) on the out ...

Switch, heated seat
DESCRIPTION Fig. 10: Locating Accessory Switch Bank Module Two heated seat switches are located in the center stack of the instrument panel. The switches are located on the outer edges of the A ...