Removal, Installation

REMOVAL 1. Remove transmission and torque converter from vehicle. 2. Place a suitable drain pan under the converter housing end of the transmission. CAUTION: Verify that transmission is ...

Description, Operation

DESCRIPTION Fig. 430: Identifying Valve Body Assembly - VALVE BODY - T/C REGULATOR VALVE - L/R SWITCH VALVE - CONVERTER CLUTCH CONTROL VALVE - MANUAL VALVE - CONVERTER CLUTCH SWITCH V ...

See also:

Sensor, ambient temperature
DESCRIPTION Fig. 33: Identifying Ambient Air Temperature Sensor The ambient air temperature sensor is a variable resistor that monitors the air temperature outside of the vehicle. The ATC sys ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...

Resistor, blower motor, rear
DESCRIPTION Fig. 62: Rear Blower Resistor A blower motor resistor is used on this model when equipped with the manual temperature control (MTC) rear heating-A/C system. Models equipped with the ...