Installation

Fig. 474: Removing/Installing Valve Body - VALVE BODY NOTE: If valve body assembly is being replaced or reconditioned, it is necessary to perform the PCM Quick Learn Procedure. 1. ...

Description

Fig. 1: BG6 Manual Transaxle - OUTPUT SHAFT #2 - INPUT SHAFT - OUTPUT SHAFT #1 - DIFFERENTIAL The Aisin BG 6 6-speed transaxle is a constant-mesh transaxle that is synchronized in all ...

See also:

Disassembly
Fig. 241: Tapping Down Reverse Clutch Reaction Plate - #4 THRUST PLATE (SELECT) - TAP DOWN REVERSE CLUTCH REACTION PLATE TO REMOVE OR INSTALL SNAP RING - INPUT SHAFT CLUTCHES RETAINER ASSEMB ...

Module, heated seat
DESCRIPTION Fig. 35: Locating Heated Seat Module The heated seat module (2) is located under the driver front seat. It has a single electrical connector (1) and a push pin style retainer that s ...

Ring(s), piston
Standard Procedure PISTON RING FITTING Fig. 200: CHECK GAP ON PISTON RINGS - FEELER GAUGE 1. Wipe cylinder bore clean. Insert ring and push down with piston to ensure it is square in bore ...