Dodge Journey: Seal, axle drive shaft

REMOVAL

Manual Transmission BG6
Fig. 197: Axle Shaft Seal Removal

1. Remove axle shaft.

2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1).

3. Tap on the pry tool (2) with a small hammer and remove axle shaft seal (1).

INSTALLATION

Manual Transmission BG6
Fig. 198: Aligning Axle Shaft Seal With Axle Shaft Seal Bore

1. Clean axle shaft seal bore of any excess sealant.

2. Align (bellhousing side) axle shaft seal with axle shaft seal bore.

3. Install axle seal on Seal Installer 9928 and Handle C-4171 and insert into axle shaft seal bore.

4. Tap seal into position until seated against transaxle case.

Manual Transmission BG6
Fig. 199: Differential Side Seal

5. Align axle shaft seal with axle shaft seal bore.

6. Install (case side) axle seal on Seal Installer 9934 and Handle C-4171 and insert into axle shaft seal bore.

7. Tap seal into position until seated against transaxle case.

8. Install axle shaft.

9. Check transaxle fluid level and adjust as necessary.

    Mechanism, gearshift
    REMOVAL Fig. 193: Shift Cables To Shifter 1. Detach gear shift boot from console. 2. Remove the center console assembly. 3. Remove rear power window switch (if equipped) and disconnect ha ...

    See also:

    Installation
    NOTE: Before stabilizer bar installation, inspect the cushions and links for excessive wear, cracks, damage and distortion. Replace any pieces failing inspection. NOTE: Before installing the ...

    Removal
    FRONT 1. Raise and support the vehicle. Fig. 163: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts (3), then the tire and wheel assembly (1). NOTE: In some cases, it may be necessary ...

    Sensor, variable line pressure
    DESCRIPTION Fig. 390: Identifying Variable Line Pressure Sensor - PRESSURE CONTROL SOLENOID - LINE PRESSURE SENSOR - SHOULDER SCREW - VARIABLE LINE PRESSURE HEADER - MANUAL SHAFT - SC ...


    0.0213