Valves, intake and exhaust

Description The valves are made of heat resistant steel, and have chrome plated stems to prevent scuffing. The four valves per cylinder (two intake and two exhaust) are actuated by roller rocker a ...

Description, standard procedure

DESCRIPTION Fig. 163: Engine Block & Crankshaft - MAIN CAP BOLT-VERTICAL - MAIN CAP - MAIN BEARING-LOWER - MAIN BEARING-UPPER - MAIN CAP BOLT - HORIZONTAL - CYLINDER BLOCK - CRA ...

See also:

Removal
LEFT-HAND DRIVE NOTE: The ABM is only separately serviceable for non-HSA (Hill Start Assist) equipped vehicles. Do not remove the ABM for vehicles equipped with HSA. 1. Disconnect the nega ...

Description, Operation
DESCRIPTION The charging system consists of: Generator Decoupler Pulley (2.4L and Diesel Only) Electronic Voltage Regulator (EVR) circuitry within the Powertrain Control Module (PCM) Ign ...

Description, Standard procedure
DESCRIPTION Fig. 331: Identifying Timing Drive System Components The timing drive system has been designed to provide quiet performance and reliability to support a NON freewheeling engine. The ...