Dodge Journey: Damper, vibration
Removal
Fig. 196: Vibration Damper - Removal
- - SPECIAL TOOL 8454 PULLER
- - SPECIAL TOOL 8194 INSERT
1. Disconnect negative battery cable.
2. Remove right front wheel and belt splash shield.
3. Remove accessory drive belts.
4. Remove damper bolt.
5. Remove damper by using Special Tools 8194 Insert and 8454 Puller (1).
Installation
Fig. 197: Vibration Damper - Installation
- - VIBRATION DAMPER
- - SPECIAL TOOL 6792-1
- - SPECIAL TOOL 8179
1. Install damper using Special Tools 8179 (3) Screw, with Nut and Thrust Bearing from 6792, and 6792-1 Installer (2).
2. Install damper center bolt. Tighten center bolt to 170 N.m (125 ft. lbs.).
3. Install accessory drive belts.
4. Install belt splash shield and right front wheel.
5. Lower vehicle.
6. Connect negative battery cable.
Crankshaft
Description
The crankshaft is constructed of a forged micro alloy steel. The six throw,
nine counterweight crankshaft is
supported by four select fit main bearings with the number three serving as ...
Flexplate
Removal
Fig. 198: Flex Plate
1. Remove transmission.
2. Remove flex plate attaching bolts (2).
3. Remove backing plate (3) and flex plate (1).
Installation
Fig. 199: FLEX PLATE
1. Posit ...
See also:
Diagnosis and testing
BATTERY
The battery must be completely charged and the terminals should be properly
cleaned and inspected before
diagnostic procedures are performed. See Cleaning for the proper battery
cleaning ...
Mechanism, gearshift
REMOVAL
Fig. 193: Shift Cables To Shifter
1. Detach gear shift boot from console.
2. Remove the center console assembly.
3. Remove rear power window switch (if equipped) and disconnect ha ...
Uconnect™ Multimedia (SIRIUS BACKSEAT TV™) — IF EQUIPPED
Satellite video uses direct satellite receiver broadcasting
technology to provide streaming video. The subscription
service provider is SIRIUS Satellite Radio. SIRIUS Backseat
TV™ offers three vi ...
