Dodge Journey: Switch, horn

REMOVAL

WARNING: On vehicles equipped with an airbag, refer to Restraint SERVICE INFORMATION article for warnings and cautions before servicing the horn switch.

Horn System
Fig. 3: Removing Horn Switch

1. Disconnect and isolate the battery negative cable.

2. Remove the driver airbag.

3. Disconnect the connector from the clockspring.

4. Remove the three mounting fasteners.

5. Remove the horn switch.

INSTALLATION

Horn System
Fig. 4: Installing Horn Switch

1. Install the horn switch.

2. Install the three mounting fasteners.

3. Connect the electrical connector to the clockspring.

4. Install the driver airbag.

5. Connect the battery negative cable.

    Horn
    REMOVAL Fig. 1: Removing / Installing Horns 1. Disconnect and isolate the negative battery cable. 2. Remove the push pin type retainers along the top of the grille assembly and position the g ...

    See also:

    Installation
    BEVERAGE COOLER NOTE: LHD model shown in illustrations. RHD model similar. OUTLET Fig. 149: Beverage Cooler Outlet & Hose NOTE: If the beverage cooler cold air supply hose falls back ...

    LIFTGATE
    The liftgate can be unlocked or locked with the Remote Keyless Entry (RKE) transmitter or by activating the power door lock switch located on either front door trim panel. NOTE: The liftgate canno ...

    Seal, crankshaft oil, front
    Removal Fig. 212: Crankshaft Front Oil Seal - Removal - SPECIAL TOOL 6771 1. Remove crankshaft vibration damper. 2. Install Special Tool 8194, Insert into crankshaft nose. Remove seal us ...


    0.0209