Switch, horn

REMOVAL WARNING: On vehicles equipped with an airbag, refer to Restraint SERVICE INFORMATION article for warnings and cautions before servicing the horn switch. Fig. 3: Remov ...

Description

The instrument cluster contains the necessary hardware and software to serve as the vehicle electronic body control module and is commonly referred to as the Cab Compartment Node (CCN). The CCN u ...

See also:

Actuator, recirculation door
DESCRIPTION Fig. 15: Blend Door Actuators The recirculation door actuator (1) is a reversible, 12 volt direct current (DC) servo motor, which is connected directly to the pivot shaft lever of t ...

Manifold, exhaust, front
Removal 1. Disconnect negative battery cable. 2. Remove the engine cover. Fig. 295: Oxygen Sensors 3. Disconnect and remove oxygen sensors (2) and (4). Fig. 296: Upper Maniverter Heat Shiel ...

Installation
2.4L Fig. 7: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Install ignition coil capacitor (2) and bolt (1), tighten bolt to 10 N.m (88.5 ft. lbs.). 2. Connect electrical connect ...