Frame and Bumpers

...

Fascia, front

REMOVAL Fig. 1: Pushpins 1. Release hood latch and open hood. 2. Remove the pushpins for the fascia (2) at the radiator support. Fig. 2: Pop Rivets 3. Hoist and support vehicle on safety st ...

See also:

Valves, intake and exhaust
Description The valves are made of heat resistant steel, and have chrome plated stems to prevent scuffing. The four valves per cylinder (two intake and two exhaust) are actuated by roller rocker a ...

Heater performance
Before performing the following tests, see COOLING for the procedures to check the engine coolant level and flow, engine coolant reserve/recovery system operation, accessory drive belt condition ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...