Assembly

Fig. 214: First Gear Needle Bearing & Output Shaft NOTE: Use ATF on all parts that are to be assembled in this procedure. 1. Install the first and first gear needle bearing (2) on the out ...

Disassembly

Fig. 229: Snap Ring At Output Shaft 1. Using Snap Ring Pliers (1) remove the snap ring (2) from the output shaft # 2. Fig. 230: Bearing From Cluster Shaft 2. Using a press, blocks, Bearing Sp ...

See also:

Description, Operation
DESCRIPTION Fig. 265: A/C Expansion Valve Description KA The A/C expansion valve controls the amount of refrigerant entering the A/C evaporator. The A/C expansion valve is of a thermostatic exp ...

Valve, one way check
Description Fig. 16: AIR INJECTION CHECK VALVE The air injection check valve (1) is a one-valve check valve that allows air to flow in one direction only. The valve is located at exhaust side o ...

Installation
2.4L FRONT Fig. 38: Removing/Installing Camshaft Position Sensor CAUTION: Install camshaft position (CMP) sensor utilizing twisting motion. Make sure CMP sensor is fully seated. Do n ...