Sensor, variable line pressure

DESCRIPTION Fig. 390: Identifying Variable Line Pressure Sensor - PRESSURE CONTROL SOLENOID - LINE PRESSURE SENSOR - SHOULDER SCREW - VARIABLE LINE PRESSURE HEADER - MANUAL SHAFT - SC ...

Removal

Fig. 393: Removing/Installing Defroster Cover 1. Disconnect the negative battery cable. 2. Using a trim stick remove the defroster cover (1). Fig. 394: Removing/Installing Screws At Center St ...

See also:

Curb height measurement
The wheel alignment is to be checked and all alignment adjustments made with the vehicle at its required curb height specification. Vehicle height is to be checked with the vehicle on a flat, le ...

Installation
Fig. 28: Sealing Boot Installation on Interconnecting Shaft - SEALING BOOT - RAISED BEAD IN THIS AREA OF SEALING BOOT - GROOVE - INTERCONNECTING SHAFT 1. Slide new sealing boot clamp (2 ...

POWER INVERTER — IF EQUIPPED
Your vehicle may be equipped with a 115 Volt AC (150 Watt maximum) power outlet located on the back of the center console. This outlet can power cellular phones, electronics and other low power dev ...