With intermediate shaft

NOTE: Never grasp the halfshaft assembly by the inner or outer boots. This can cause damage to the boot, which will allow contaminants to enter the C/V joint. NOTE: The inner tripod joints ...

Without intermediate shaft

NOTE: The inner tripod joints are designed with a retention feature that prevents the tripod rollers from coming out of the inner joint housing up to a specific load. If this feature is o ...

See also:

Duct, floor distribution, rear
REMOVAL Fig. 159: Rear Floor Distribution Duct 1. Remove right quarter trim panel. 2. Remove the push-pin retainer (2) that secures the rear floor distribution duct (1) to the right inner qu ...

TO OPEN AND CLOSE THE HOOD
Two latches must be released to open the hood. 1. Pull the hood release lever located under the left side of the instrument panel. Hood Release 2. Outside of the vehicle, locate the safety latch ...

Installation
Two unique brake lamp switches are used in this vehicle, depending upon whether the vehicle was built during early or late production. These switches are not interchangeable. Both switches are il ...