Dodge Journey: Module, engine control

Installation
LEFT-HAND DRIVE 1. Clean any debris off the mating surfaces of the HCU and ABM. CAUTION: When installing new O-rings or solenoid valve stem seals, do not use any type of lubricant. ...

Description, Operation
DESCRIPTION Fig. 29: Removing/Installing ECM - 2.0L Diesel The ECM (3) is located in the left side of engine compartment attached to the left inner fender below the air filter housing. OPERAT ...

See also:

Engine diagnosis
ENGINE DIAGNOSIS - INTRODUCTION Engine diagnosis is helpful in determining the causes of malfunctions not detected and remedied by routine maintenance. These malfunctions may be classified as e ...

Preliminary checks
ENGINE COOLING SYSTEM OVERHEATING Establish what driving conditions caused the complaint. Abnormal loads on the cooling system such as the following may be the cause: Prolonged idle Very hig ...

Installation
HOUSING-AIR DISTRIBUTION NOTE: LHD model shown in illustrations. RHD model similar. Fig. 131: Air Distribution Housing-Removal/Installation 1. Position the air distribution housing (2) onto ...

0.0162