Dodge Journey: REPLACEMENT BULBS

All the inside bulbs are brass or glass wedge base.

Aluminum base bulbs are not approved and should not be used for replacement.

LIGHT BULBS – Interior Bulb Number

Courtesy/Reading Lamps (Incandescent). . . . . . . . 578. Courtesy/Reading Lamps. (Optional LED) . . . . . . . . . . . . . . . . . . . . . . . . . LED. (Serviced at Authorized Dealer). Glove Box Lamp . . . . . . . . . . . . . . . . . . . . . . . . . 194. Cargo Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . 579. Optional Door Map. Pocket/Cupholder . . . . . . . . . . . . . . . . . . . . . . . LED. (Serviced at Authorized Dealer).

LIGHTS BULBS – Exterior Bulb No.

Low Beam Headlamp. . . . . . . . . . . . . . . . . . . . . 9006.

High Beam Headlamp . . . . . . . . . . . . . . . . . . . . 9005.

Front Park/Turn Signal . . . . . . . . . . . . . . . . . 3757AK.

Side Marker Lamp. . . . . . . . . . . . . . . . . . . . . . . . 168.

Front Fog Lamp . . . . . . . . . . . . . . . . . . . . . . PSX24W.

Center High Mounted Stop Lamp (CHMSL) . . . . . . . LED (Serviced at Authorized Dealer) Rear Tail/Stop/Turn Signal . . . . . . . . . . . . . . . 3157K.

Rear Tail . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3157K.

Backup Lamp . . . . . . . . . . . . . . . . . . . . . . . . . 3157K.

License Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . . 168.

    VEHICLE STORAGE
    If you will not be using your vehicle for more than 21 days you may want to take steps to preserve your battery. You may: • Remove the IOD (Ignition Off-Draw) mini-fuses from the Totally Integra ...

    BULB REPLACEMENT
    Low Beam Headlamp, High Beam Headlamp, Front Turn Signal/Park Lamp, Side Marker Lamp 1. Open the hood. NOTE: It may be necessary to remove the air cleaner filter housing and position the Totally I ...

    See also:

    Standard Procedure
    MASTER CYLINDER BLEEDING 1. Clamp the master cylinder in a vise with soft-jaw caps. Fig. 88: BLEEDING MASTER CYLINDER WITH ABS 2. Thread a Bleeder Tube (2), Special Tool 8358-1, into the primary ...

    Installation
    Fig. 164: Removing/Installing Bellhousing Upper & Lower Bolts NOTE: If transaxle assembly is being replaced or overhauled (clutch and/or seal replacement), it is necessary to perform th ...

    Removal
    Fig. 431: Identifying Battery Cables - BATTERY POSITIVE CABLE - THERMO-WRAP - BATTERY NEGATIVE CABLE NOTE: If valve body is replaced or reconditioned, the PCM Quick Learn Procedure ...


    0.0188