Solenoid, pressure control

DESCRIPTION Fig. 415: Identifying Variable Line Pressure Components - PRESSURE CONTROL SOLENOID - LINE PRESSURE SENSOR - SHOULDER SCREW - VARIABLE LINE PRESSURE HEADER - MANUAL SHAFT ...

Description, Operation

DESCRIPTION Fig. 418: Identifying Ignition Key/Switch Positions - LOCK - ACC - ON - START The Brake Transmission Shifter/Ignition Interlock (BTSI) is a solenoid operated system that ...

See also:

Installation
Fig. 186: Rear Heater AC Housing Removal/Installation NOTE: MTC rear heater-A/C system shown. ATC system similar. 1. Position the rear heater-A/C housing (1) into the vehicle and align the ...

ROOF LUGGAGE RACK — IF EQUIPPED
The roof rack cross rails and side rails are designed to carry cargo weight. The load must not exceed 150 lbs (68 kg), and it should be distributed uniformly over the cross rails. In addition, the ...

ELECTRICAL POWER OUTLETS
There are two fused 12 Volt (13 Amp) power outlets located in the center console below the radio. The power outlet on the top has power available when the ignition switch in the ON or ACC position. ...