Dodge Journey: Intermediate shaft, diesel
REMOVAL
2.0L DIESEL
1. Remove the right half shaft.
Fig. 50: 2.0L Diesel Right Half Shaft Components
2. Remove the two intermediate shaft bolts (1).
3. Remove the intermediate shaft (2).
Fig. 51: Intermediate Shaft Bracket & Bolts
4. If necessary, remove the intermediate shaft bracket bolts (1) and the intermediate shaft bracket (2).
INSTALLATION
2.0L DIESEL
Fig. 52: Intermediate Shaft Bracket & Bolts
1. If the intermediate shaft bracket was removed, install the intermediate shaft bracket (2), and the intermediate shaft bracket bolts (1). Tighten the bolts to 23 Nm (17 in. lbs.).
Fig. 53: 2.0L Diesel Right Half Shaft Components
2. Install the intermediate shaft (2).
3. Install the two intermediate shaft bolts (1). Tighten the bolts to 38 Nm (28 in. lbs.).
4. Install the right axle half shaft.
Intermediate shaft, gas
REMOVAL
2.4L
1. Remove the right half shaft.
Fig. 44: Intermediate Shaft - 2.4L
2. Remove the three intermediate shaft bolts (1).
3. Remove the intermediate shaft (2).
2.7L
1. Remove the r ...
Propeller shaft
...
See also:
COMPASS MINI-TRIP COMPUTER (CMTC) — IF EQUIPPED
NOTE:
• The compass on your vehicle is self-calibrating, eliminating
the need to manually calibrate the compass.
• If the vehicle is equipped with a Chrysler gps
(Navigation Radio), the NAV sy ...
Lamp, center high mounted stop
REMOVAL
Fig. 5: Center High Mounted Stop Lamp
1. Disconnect and isolate the battery negative cable.
2. Remove the two screws (4) that secure the Center High Mounted Stop Lamp (CHMSL)
(3) to t ...
Removal
FRONT
1. Raise and support the vehicle.
Fig. 163: TIRE AND WHEEL MOUNTING
2. Remove the wheel mounting nuts (3), then the tire and wheel assembly (1).
NOTE: In some cases, it may be necessary ...
