Description, Operation

DESCRIPTION Fig. 1: Identifying 41TE Automatic Transaxle Components - TRANSAXLE CASE - TORQUE CONVERTER - OIL PUMP - INPUT SPEED SENSOR - UNDERDRIVE CLUTCH - OVERDRIVE CLUTCH - REVE ...

40/41TE Transaxle general diagnosis, road test

40/41TE TRANSAXLE GENERAL DIAGNOSIS NOTE: Before attempting any repair on a 40/41TE four-speed automatic transaxle, check for Diagnostic Trouble Codes (DTC's) using the scan tool. Transaxl ...

See also:

Installation
2.4L Fig. 7: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Install ignition coil capacitor (2) and bolt (1), tighten bolt to 10 N.m (88.5 ft. lbs.). 2. Connect electrical connect ...

Seal, axle drive shaft
REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...

Description, Operation
DESCRIPTION Fig. 29: Removing/Installing ECM - 2.0L Diesel The ECM (3) is located in the left side of engine compartment attached to the left inner fender below the air filter housing. OPERAT ...