Installation

CLUTCH - FIXED DISPLACEMENT A/C COMPRESSOR NOTE: Typical A/C compressor and clutch assembly shown in illustrations. Fig. 214: Clutch Coil & Snap Ring 1. Align the dowel pin on the bac ...

Description, Operation

DESCRIPTION Fig. 221: Condenser Description NOTE: A/C condenser with automatic transmission cooler shown. A/C Condenser without cooler similar. The A/C condenser (1) is located in the f ...

See also:

ENGINE BLOCK HEATER — IF EQUIPPED
The engine block heater warms engine coolant and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded, three-wire extension cord. ...

ELECTRICAL POWER OUTLETS
There are two fused 12 Volt (13 Amp) power outlets located in the center console below the radio. The power outlet on the top has power available when the ignition switch in the ON or ACC position. ...

Seal(s), valve guide
REMOVAL Fig. 139: Valve Stem Seal-Removal/Installation - VALVE SEAL TOOL - VALVE STEM 1. Remove valve spring. 2. Remove valve stem seal by using a valve seal tool. INSTALLATION Fig. ...