Valve, exhaust gas recirculation (EGR), 2.0L Diesel

Description The EGR valve is mounted to the intake manifold. Operation The engines use Exhaust Gas Recirculation (EGR) systems. The EGR system reduces oxides of nitrogen (NOx) in engine exhaust ...

Description

Fig. 1: Muffler/Exhaust Pipe Assembly - Single Tail Pipe - INSULATOR - MUFFLER/EXHAUST PIPE ASSEMBLY - BAND CLAMP The exhaust system on the 2.4L and 2.7L engine models consists of a front ...

See also:

Installation
Fig. 137: Rear Mount Bracket 1. If transmission brackets were removed or transmission was replaced install the rear mount bracket and tighten (1) to 100 N.m (74 ft. lbs.). Fig. 138: Front Mou ...

Seal, axle drive shaft
REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...

Heater, engine block
Description 2.4L Fig. 70: BLOCK HEATER 2.4L ENGINE - RETAINING CLIP - BLOCK HEATER CAUTION: The power cord must be secured in its retainer clips, and not positioned so it co ...