Tray, battery

DESCRIPTION The battery is placed and secured in a stamped steel battery tray. The battery tray is located in the left front side of the vehicle, just ahead of the left front wheel and tire assemb ...

Description, Operation

DESCRIPTION The charging system consists of: Generator Decoupler Pulley (2.4L and Diesel Only) Electronic Voltage Regulator (EVR) circuitry within the Powertrain Control Module (PCM) Ign ...

See also:

Disassembly
Fig. 200: Snap Ring At Output Shaft Case Bearing 1. Remove the snap ring (2) from the output shaft. Fig. 201: Output Shaft Case Bearing And Gear 2. Use Bearing Splitter P-334 (3), Cage 8925-3 ( ...

Horn
REMOVAL Fig. 1: Removing / Installing Horns 1. Disconnect and isolate the negative battery cable. 2. Remove the push pin type retainers along the top of the grille assembly and position the g ...

Installation
BEVERAGE COOLER NOTE: LHD model shown in illustrations. RHD model similar. OUTLET Fig. 149: Beverage Cooler Outlet & Hose NOTE: If the beverage cooler cold air supply hose falls back ...