Diagnosis and testing

ON-BOARD DIAGNOSTIC SYSTEM The Powertrain Control Module (PCM) monitors critical input and output circuits of the charging system, making sure they are operational. A Diagnostic Trouble Code (DTC) ...

Description, Operation

DESCRIPTION The generator is belt-driven by the engine. It is serviced only as a complete assembly. If the generator fails for any reason, the entire assembly must be replaced. The generator produ ...

See also:

Removal
Fig. 35: Removing/Installing Halfshaft Nut NOTE: Rear suspension and drivetrain design require this procedure to be performed on a "drive-on" hoist, as the front and rear suspensi ...

Installation
Fig. 25: Ball Joint Installation 1. Install Installer (2), Special Tool 9964-1, and Installer (4), Special Tool 9964-2 on Remover/Installer (5), Special Tool 8441-1. Place a new ball joint (stem ...

Seal(s), valve guide
REMOVAL Fig. 139: Valve Stem Seal-Removal/Installation - VALVE SEAL TOOL - VALVE STEM 1. Remove valve spring. 2. Remove valve stem seal by using a valve seal tool. INSTALLATION Fig. ...