Dodge Journey: Removal, Installation
REMOVAL
Fig. 30: Air Inlet Duct
1. Remove air inlet duct (3).
2. Disconnect negative battery cable.
3. Disconnect vacuum hose (1).
4. Remove air filter housing assembly (2).
Fig. 31: Removing/Installing ECM - 2.0L Diesel
5. Disconnect both ECM (1) electrical connectors.
6. Remove ECM bracket retaining bolts (2) and remove ECM (3).
INSTALLATION
Fig. 32: Removing/Installing ECM - 2.0L Diesel
1. Install ECM (3) on mounting bracket. Torque fastener to 10.7N.m (95 lbs. in.).
2. Connect both ECM electrical connectors (1).
Fig. 33: Air Inlet Duct
3. Install air filter housing assembly (2).
4. Connect vacuum hose (1).
5. Connect negative battery cable.
6. Install air inlet tube (3).
7. Reprogram ECM.
Description, Operation
DESCRIPTION
Fig. 29: Removing/Installing ECM - 2.0L Diesel
The ECM (3) is located in the left side of engine compartment attached to the
left inner fender below the air
filter housing.
OPERAT ...
Module, final drive control
DESCRIPTION
The AWD ECM (electronic control module) mounts on the driver side cowl side
panel, where it is concealed by
the instrument panel. It communicates with other systems over the high-speed ...
See also:
Installation
Fig. 67: Seal Protector
- HALFSHAFT
- SEAL PROTECTOR
1. Install driveline module to transmission jack. Secure module to jack.
2. Using Seal Protector 9099 (2), load halfshafts to differe ...
Uconnect™ Multimedia (SATELLITE RADIO) — IF EQUIPPED
(REN/REQ/RER/RES/REU/RBZ RADIOS ONLY)
Satellite radio uses direct satellite-to-receiver broadcasting
technology to provide clear digital sound, coast to
coast. The subscription service provider is Sirius Satellite
Radio. This service o ...
Description - monitored systems
There are new electronic circuit monitors that check fuel, emission, engine
and ignition performance. These
monitors use information from various sensor circuits to indicate the overall
operation ...
