Seal, axle drive shaft

REMOVAL Fig. 197: Axle Shaft Seal Removal 1. Remove axle shaft. 2. Insert a flat-blade pry tool (2) at outer edge of axle shaft seal (1). 3. Tap on the pry tool (2) with a small hammer and ...

Disassembly

Fig. 200: Snap Ring At Output Shaft Case Bearing 1. Remove the snap ring (2) from the output shaft. Fig. 201: Output Shaft Case Bearing And Gear 2. Use Bearing Splitter P-334 (3), Cage 8925-3 ( ...

See also:

Assembly
Fig. 333: Identifying Thrust Washer - THRUST WASHER NOTE: The differential is serviced as an assembly. Differential service is limited to bearing cups and cones. Any other differentia ...

Body, air cleaner
REMOVAL 1. Disconnect negative battery cable. Fig. 87: Inlet Air Temperature Sensor Electrical Connector 2. Disconnect inlet air temperature sensor electrical connector (3). 3. Disconnect fres ...

Installation
Fig. 67: Seal Protector - HALFSHAFT - SEAL PROTECTOR 1. Install driveline module to transmission jack. Secure module to jack. 2. Using Seal Protector 9099 (2), load halfshafts to differe ...