Dodge Journey: Seal, oil pump

REMOVAL

Automatic Transmission 41TE
Fig. 367: Removing Oil Pump Seal

  1. - SEAL PULLER C-3981-B
  2. - OIL PUMP SEAL

1. Remove transaxle from vehicle.

2. Using Seal Puller C-3981B (1) , remove oil pump seal (2).

INSTALLATION

Automatic Transmission 41TE
Fig. 368: Installing Oil Pump Seal

  1. - SEAL INSTALLER C-4193
  2. - HANDLE C-4171

1. Using Seal Installer C-4193A (1) , install oil pump seal.

2. Install transaxle to vehicle.

    Relay, transmission control
    DESCRIPTION Fig. 366: Locating Transmission Control Relay - TRANSMISSION CONTROL RELAY - POWER DISTRIBUTION CENTER The transmission control relay (1) is located in the Power Distribution ...

    Sensor, speed, input
    DESCRIPTION Fig. 369: Removing/Installing Input Speed Sensor - INPUT SPEED SENSOR The Input Speed Sensor (1) , is a two-wire magnetic pickup device that generates AC signals as rotation oc ...

    See also:

    Reservoir, brake master cylinder
    Removal CAUTION: If at any time the master cylinder is loosened or removed, you must perform the master cylinder installation procedure to ensure that the seal (o-ring) is still ...

    Description, Operation
    DESCRIPTION The charging system consists of: Generator Decoupler Pulley (2.4L and Diesel Only) Electronic Voltage Regulator (EVR) circuitry within the Powertrain Control Module (PCM) Ign ...

    Removal
    WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the warnings and cautions may result in possible se ...

    0.3143