Dodge Journey: Knob, gearshift
REMOVAL

Fig. 357: Removing/Installing Gearshift Knob
1. Loosen the set screw (3) on the shift knob (2).
2. Hold in the shift knob button (1).
3. Pull up on the shift knob (2) while holding the shift knob button (1) in.
INSTALLATION

Fig. 358: Removing/Installing Gearshift Knob
1. While holding the shift knob button (1) in install the shift knob (1) onto the shift mechanism shaft (4).
2. Tighten the set screw (3).
Holding clutches
DESCRIPTION
Fig. 356: Identifying 2/4 & Low/Reverse Clutches & Planetary Geartrain
Components
- FRONT PLANET CARRIER/REAR ANNULUS
- 2/4 CLUTCH
- L/R CLUTCH
- REAR PLANET CARRIER ...
Pump, transmission oil
DESCRIPTION
Fig. 359: Identifying Transmission Oil Pump Assembly
- PUMP HOUSING
- OUTER PUMP GEAR
- INNER PUMP GEAR
- REACTION SHAFT SUPPORT
- SEAL RINGS (4)
- REACTION SHAFT
- CRES ...
See also:
Removal, Installation
REMOVAL
WARNING: To avoid serious or fatal injury on vehicles equipped
with airbags, disable
the Supplemental Restraint System (SRS) before attempting any steering
wheel, steering co ...
Module, glow plug
DESCRIPTION
Fig. 23: Locating Diesel Glow Plug Control Module
The glow plug control module is mounted to the fuel filter/water separator
bracket, and is controlled by the
engine control module. ...
REMOTE SOUND SYSTEM CONTROLS — IF
EQUIPPED
The remote sound system controls are located on the rear
surface of the steering wheel. The left and right-hand
controls are rocker-type switches with a pushbutton in
the center of each switch. Rea ...
