Installation

HOUSING-AIR DISTRIBUTION NOTE: LHD model shown in illustrations. RHD model similar. Fig. 131: Air Distribution Housing-Removal/Installation 1. Position the air distribution housing (2) onto ...

Description, Operation

DESCRIPTION Fig. 139: Blower Motor-PM The blower motor (1) is used to control the velocity of air moving through the HVAC housing by spinning the blower wheel (2) within the HVAC air inlet hous ...

See also:

Inspection, adjustments
INSPECTION Inspect the exhaust pipes, catalytic converters, muffler, and resonators for cracked joints, broken welds and corrosion damage that would result in a leaking exhaust system. Inspect the ...

Removal
LEFT-HAND-DRIVE 1. Disconnect and isolate the battery negative cable from its post on the battery. 2. If equipped, remove the silencer pad below the steering column opening cover. Fig. 132: S ...

Reinforcement, bumper, rear
REMOVAL Fig. 25: Rear Bumper Reinforcement 1. Remove rear fascia. See Removal . 2. Support bumper reinforcement (1) on a suitable lifting device. 3. Mark position of bolts (2) on frame rail ...