Installation

2.4L Fig. 7: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Install ignition coil capacitor (2) and bolt (1), tighten bolt to 10 N.m (88.5 ft. lbs.). 2. Connect electrical connect ...

Removal

2.4L Fig. 11: Identifying Ignition Coil Electrical Connectors NOTE: Prior to removing coil, spray compressed air around coil top to make sure no dirt drops into the spark plug tube. The ...

See also:

Assembly
Fig. 257: Installing Input Shaft - INPUT SHAFT - ARBOR PRESS - INPUT SHAFT HUB ASSEMBLY Use petrolatum on all seals to ease assembly of components. 1. Using an arbor press (2), install ...

Removal, Installation
REMOVAL Fig. 6: Backup Camera & Liftgate & Lights 1. Disconnect the negative battery cable. 2. Remove the four retainers (1) holding the lightbar (5) to the liftgate (6). 3. Using a ...

Installation
LEFT-HAND-DRIVE NOTE: The master cylinder must be bled before installing it on the vehicle. 1. Bench bleed the master cylinder. 2. Wipe the face of the power brake booster clean where the ...