Dodge Journey: Housing, coolant outlet

Removal

Cooling
Fig. 78: COOLANT OUTLET CONNECTOR - 2.7L

  1. - BOLT (2)
  2. - BOLT (2)
  3. - COOLANT OUTLET CONNECTOR

WARNING: Do not remove pressure cap with the system hot and under pressure because serious burns from coolant can occur.

1. Drain cooling system.

2. Disconnect engine coolant temperature sensor connector.

3. Disconnect hoses at coolant outlet connector.

4. Remove bolts attaching coolant outlet connector.

5. Remove coolant outlet connector.

Installation

Cooling
Fig. 79: COOLANT OUTLET CONNECTOR - 2.7L

  1. - BOLT (2)
  2. - BOLT (2)
  3. - COOLANT OUTLET CONNECTOR

1. Clean sealing surfaces. Inspect gaskets for tears and cuts. Replace as necessary.

2. Install coolant outlet connector and tighten bolts to 12 N.m (105 in. lbs.).

3. Connect hoses at coolant outlet connector.

4. Connect engine coolant temperature sensor connector.

5. Fill cooling system.

    Heater, engine block
    Description 2.4L Fig. 70: BLOCK HEATER 2.4L ENGINE - RETAINING CLIP - BLOCK HEATER CAUTION: The power cord must be secured in its retainer clips, and not positioned so it co ...

    Pump, water
    Description 2.4L Fig. 80: WATER PUMP - WORLD ENGINE - ACCESSORY DRIVE BELT - WATER PUMP PULLEY - WATER PUMP The water pump (3) on the world engine is attached to the water pump adapter ...

    See also:

    Installation
    WITH FOOT LEVER 1. Pass most of the front parking brake cable down through the access hole in the floor pan from inside the vehicle. Fig. 195: CABLE HOUSING RETAINED IN LEVER 2. Insert the lev ...

    Air cleaner
    REMOVAL Fig. 85: Air Filter Housing Clips 1. Disengage the air filter housing clips (1). 2. Slide the air filter housing cover (2) forward slightly to disengage tabs from the bottom of the ai ...

    Coolant
    Description ENGINE COOLANT GAS ENGINES WARNING: Antifreeze is an ethylene glycol based coolant and is harmful if swallowed or inhaled. If swallowed, drink two glasses of water and ind ...


    0.0185