With intermediate shaft

NOTE: The inner tripod joints are designed with a retention feature that prevents the tripod rollers from coming out of the inner joint housing up to a specific load. If this feature is o ...

Removal

Fig. 25: Outer C/V Joint Seal Boot Clamps - SMALL CLAMP - SEALING BOOT - OUTER CV JOINT HOUSING - LARGE CLAMP - INTERCONNECTING SHAFT 1. Remove halfshaft assembly requiring boot repla ...

See also:

Ensioner, belt
Removal 2.4L ENGINE Fig. 36: ACCESSORY DRIVE BELT - WORLD ENGINE - POWER STEERING PUMP - ACCESSORY DRIVE BELT - GENERATOR - CRANKSHAFT PULLEY - LOWER IDLER PULLEY - CRANKSHAFT PULLEY ...

Removal
1. Raise and support the vehicle. NOTE: Perform 2 through 5 on each side of the vehicle to complete pad set removal. Fig. 117: TIRE AND WHEEL MOUNTING 2. Remove the wheel mounting nuts ...

Assembly
Fig. 257: Installing Input Shaft - INPUT SHAFT - ARBOR PRESS - INPUT SHAFT HUB ASSEMBLY Use petrolatum on all seals to ease assembly of components. 1. Using an arbor press (2), install ...