Dodge Journey: Seal, oil pump

REMOVAL

Automatic Transmission 41TE
Fig. 367: Removing Oil Pump Seal

  1. - SEAL PULLER C-3981-B
  2. - OIL PUMP SEAL

1. Remove transaxle from vehicle.

2. Using Seal Puller C-3981B (1) , remove oil pump seal (2).

INSTALLATION

Automatic Transmission 41TE
Fig. 368: Installing Oil Pump Seal

  1. - SEAL INSTALLER C-4193
  2. - HANDLE C-4171

1. Using Seal Installer C-4193A (1) , install oil pump seal.

2. Install transaxle to vehicle.

    Relay, transmission control
    DESCRIPTION Fig. 366: Locating Transmission Control Relay - TRANSMISSION CONTROL RELAY - POWER DISTRIBUTION CENTER The transmission control relay (1) is located in the Power Distribution ...

    Sensor, speed, input
    DESCRIPTION Fig. 369: Removing/Installing Input Speed Sensor - INPUT SPEED SENSOR The Input Speed Sensor (1) , is a two-wire magnetic pickup device that generates AC signals as rotation oc ...

    See also:

    Installation
    CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system. Failure to properly adjust the refrigerant oil level will prevent the A/C system fro ...

    Pod, switch
    DESCRIPTION Fig. 10: Accessory Switch Bank Module The Accessory Switch Bank Module (ASBM) is located in the center stack area of the instrument panel just below the heater and air conditioner d ...

    Diagnosis and Testing
    SUSPENSION AND STEERING CONDITION POSSIBLE CAUSES CORRECTION Front End Whine On Turns 1. Defective Wheel Bearing2. Incorrect Wheel Alignment 3. Worn Tires ...

    0.0211