Diagnosis and testing

SHIFT INTERLOCK SYSTEM Fig. 421: Identifying Ignition Key/Switch Positions - LOCK - ACC - ON - START The Shifter Response Table describes the normal operation of the Brak ...

Description

Fig. 422: Identifying Torque Converter Components - TURBINE - IMPELLER - HUB - STATOR - CONVERTER CLUTCH DISC - DRIVE PLATE The torque converter is a hydraulic device that couples t ...

See also:

Horn
REMOVAL Fig. 1: Removing / Installing Horns 1. Disconnect and isolate the negative battery cable. 2. Remove the push pin type retainers along the top of the grille assembly and position the g ...

Assembly
Fig. 65: Remove Input Shaft Bearing Cup NOTE: Always use ATF on all moving parts during this assembly procedure. 1. Use Bearing Cup Remover 9664 (2) and appropriate Slide Hammer (1) to r ...

Engine diagnosis
ENGINE DIAGNOSIS - INTRODUCTION Engine diagnosis is helpful in determining the causes of malfunctions not detected and remedied by routine maintenance. These malfunctions may be classified as e ...