Sensor, variable line pressure

DESCRIPTION Fig. 390: Identifying Variable Line Pressure Sensor - PRESSURE CONTROL SOLENOID - LINE PRESSURE SENSOR - SHOULDER SCREW - VARIABLE LINE PRESSURE HEADER - MANUAL SHAFT - SC ...

Removal

Fig. 393: Removing/Installing Defroster Cover 1. Disconnect the negative battery cable. 2. Using a trim stick remove the defroster cover (1). Fig. 394: Removing/Installing Screws At Center St ...

See also:

Crankshaft
Description The crankshaft is constructed of a forged micro alloy steel. The six throw, nine counterweight crankshaft is supported by four select fit main bearings with the number three serving as ...

40/41TE Transaxle general diagnosis, road test
40/41TE TRANSAXLE GENERAL DIAGNOSIS NOTE: Before attempting any repair on a 40/41TE four-speed automatic transaxle, check for Diagnostic Trouble Codes (DTC's) using the scan tool. Transaxl ...

Assembly
Fig. 239: Output Shaft #2 & Needle Bearing 1. Install the reverse needle bearing (1) onto the output shaft # 2 (2). Fig. 240: Synchronizer NOTE: Pay attention to the direction when inser ...