Dodge Journey: Knob, gearshift
REMOVAL
Fig. 357: Removing/Installing Gearshift Knob
1. Loosen the set screw (3) on the shift knob (2).
2. Hold in the shift knob button (1).
3. Pull up on the shift knob (2) while holding the shift knob button (1) in.
INSTALLATION
Fig. 358: Removing/Installing Gearshift Knob
1. While holding the shift knob button (1) in install the shift knob (1) onto the shift mechanism shaft (4).
2. Tighten the set screw (3).
Holding clutches
DESCRIPTION
Fig. 356: Identifying 2/4 & Low/Reverse Clutches & Planetary Geartrain
Components
- FRONT PLANET CARRIER/REAR ANNULUS
- 2/4 CLUTCH
- L/R CLUTCH
- REAR PLANET CARRIER ...
Pump, transmission oil
DESCRIPTION
Fig. 359: Identifying Transmission Oil Pump Assembly
- PUMP HOUSING
- OUTER PUMP GEAR
- INNER PUMP GEAR
- REACTION SHAFT SUPPORT
- SEAL RINGS (4)
- REACTION SHAFT
- CRES ...
See also:
Installation
CAUTION: Be certain to adjust the refrigerant oil level when
servicing the A/C
refrigerant system. Failure to properly adjust the refrigerant
oil level will prevent the A/C system fro ...
Fluid, differential
Standard Procedure
STANDARD PROCEDURE - DIFFERENTIAL ASSEMBLY FLUID CHANGE
Fig. 79: Differential Assembly Fluid Change
The drain plug (2) for the differential assembly is located in the bottom of ...
ELECTRONIC SPEED CONTROL — IF EQUIPPED
When engaged, the Electronic Speed Control takes over
the accelerator operation at speeds greater than 25 mph
(40 km/h).
The Electronic Speed Control lever is located on the right
side of the stee ...
