Core, service port valve

DESCRIPTION Refrigerant system service ports are used to recover, recycle, evacuate, charge and test the A/C refrigerant system. Unique sizes are used on the two service ports for the R-134a ref ...

Description, Operation

DESCRIPTION Fig. 231: Receiver/Drier Description The A/C receiver/drier (1) stores unused refrigerant, filters the refrigerant, helps remove moisture from the refrigerant and retains any refrig ...

See also:

Installation
Fig. 40: Seal Protector - HALFSHAFT - SEAL PROTECTOR 1. Install halfshaft to hub/bearing assembly. Install hub nut and washer but do not tighten at this time. 2. Using Seal Protector 9 ...

Removal
2.4L Fig. 45: Locating Knock Sensor The knock sensor bolts into the side of the cylinder block in front of the starter under the intake manifold. 1. Disconnect and isolate negative battery ca ...

Installation
Fig. 51: Front Hub And Bearing Mounting 1. If required, install the hub and bearing (1) by sliding it into the knuckle. 2. If installing hub and bearing, install the four bolts (2) fastening t ...