Installation

BEVERAGE COOLER NOTE: LHD model shown in illustrations. RHD model similar. OUTLET Fig. 149: Beverage Cooler Outlet & Hose NOTE: If the beverage cooler cold air supply hose falls back ...

Duct, ceiling distribution

REMOVAL WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negati ...

See also:

Resistor, blower motor, front
DESCRIPTION Fig. 30: Blower Motor Resistor - Description A blower motor resistor is used on vehicles equipped with the manual temperature control (MTC) heating-A/C system. Vehicles equipped wit ...

Module, heated seat
DESCRIPTION Fig. 4: Locating Heated Seat Module The heated seat module (2) is located under the driver front seat. It has a single electrical connector (1) and a push pin style retainer that se ...

Standard procedure
BRAKE ROTOR MACHINING NOTE: Refacing the rotor is not required each time the brake pads are replaced, only when the need is foreseen. Any servicing of the rotor requires extreme care to ma ...