Installation

HOUSING-AIR DISTRIBUTION NOTE: LHD model shown in illustrations. RHD model similar. Fig. 131: Air Distribution Housing-Removal/Installation 1. Position the air distribution housing (2) onto ...

Description, Operation

DESCRIPTION Fig. 139: Blower Motor-PM The blower motor (1) is used to control the velocity of air moving through the HVAC housing by spinning the blower wheel (2) within the HVAC air inlet hous ...

See also:

Fascia, front lower, closeout
REMOVAL Fig. 11: Lower Fascia 1. Remove fasteners (5) to lower closeout. Fig. 12: Push Pins - Front Lower Fascia 2. Remove push pins (1) to lower closeout. 3. Remove the front lower fascia. ...

JACKING AND TIRE CHANGING
WARNING: • Do not attempt to change a tire on the side of the vehicle close to moving traffic. Pull far enough off the road to avoid the danger of being hit when operating the jack or changing t ...

Actuator, blend door, rear
DESCRIPTION Fig. 47: Rear Actuator Description The blend door actuator (1) for the rear heating-A/C system is a reversible, 12 volt direct current (DC), servo motor. The rear blend door actuato ...