Plug, glow

DESCRIPTION Fig. 26: Glow Plug Glow plugs are used to help start a cold or cool engine. The glow plugs will heat up and glow to heat the combustion chamber of each cylinder. An individual glow ...

Operation, Removal

OPERATION CAMSHAFT AND CRANKSHAFT SIGNALS Fig. 29: 4 Cylinder Cam & Crank Signals NOTE: The graphic represents the relationship between camshaft and crankshaft sensors edges with cams ...

See also:

Removal, Installation
REMOVAL Fig. 54: Removing /Installing Propeller Shaft CAUTION: Propeller shaft removal is a two-man operation. Never allow propeller shaft to hang from the center bearing, or while o ...

Installation
Fig. 25: Ball Joint Installation 1. Install Installer (2), Special Tool 9964-1, and Installer (4), Special Tool 9964-2 on Remover/Installer (5), Special Tool 8441-1. Place a new ball joint (stem ...

Seal, oil pump
REMOVAL Fig. 367: Removing Oil Pump Seal - SEAL PULLER C-3981-B - OIL PUMP SEAL 1. Remove transaxle from vehicle. 2. Using Seal Puller C-3981B (1) , remove oil pump seal (2). INSTALLA ...