Description, Operation, Specifications

DESCRIPTION NOTE: All engines use a fixed ignition timing system. Basic ignition timing is not adjustable. All spark advance is determined by the Powertrain Control Module (PCM). The ign ...

Removal

2.4L Fig. 3: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Disconnect and isolate negative battery cable at battery. 2. Remove engine cover. 3. Remove electrical connector (3). ...

See also:

Actuator, mode door, rear
DESCRIPTION Fig. 51: Rear Actuator Description The mode door actuator (1) for the rear heater-A/C system is a reversible, 12 volt direct current (DC), servo motor. The rear mode door actuator i ...

Pipe, exhaust
REMOVAL 2.7L/3.5L Fig. 20: Exhaust Pipe - 2.7L/3.5L - EXHAUST PIPE - NUTS - CROSS UNDER PIPE - GASKET WARNING: The normal operating temperature of the exhaust system is ver ...

Diagnosis and Testing
CLUTCH - FIXED DISPLACEMENT A/C COMPRESSOR The compressor clutch coil electrical circuit for the Denso 10SR15 and 10SR17 fixed displacement A/C compressors is controlled by the powertrain control ...