Seal, crankshaft oil, rear

Removal Fig. 214: REAR MAIN SEAL-INSTALLED The crankshaft rear oil seal is incorporated in the seal adapter (2) and can not be removed from the adapter. The crankshaft rear oil seal/seal adapte ...

Adjustments

ADJUSTMENT The right and left support assemblies are slotted to allow for right/left drive train adjustment in relation to drive shaft assembly length. Check and reposition right and left engin ...

See also:

Diagnosis and Testing
A/C EXPANSION VALVE WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the warnings and cautions may ...

Installation
Fig. 25: Ball Joint Installation 1. Install Installer (2), Special Tool 9964-1, and Installer (4), Special Tool 9964-2 on Remover/Installer (5), Special Tool 8441-1. Place a new ball joint (stem ...

Installation
2.4L Fig. 7: Capacitor 2.4L - Bolt - Capacitor - Connector 1. Install ignition coil capacitor (2) and bolt (1), tighten bolt to 10 N.m (88.5 ft. lbs.). 2. Connect electrical connect ...