Tubes and hoses, brake

DESCRIPTION The brake tubes are steel with a corrosion-resistant nylon coating applied to the external surfaces. The flex hoses used at each wheel brake are made of reinforced rubber with fitt ...

Description

The parking brake consists of the following components: Foot-operated parking brake lever * Cables (front, left rear, right rear) Cable equalizer Caliper with Integral Parking Brake (IPB) ...

See also:

Installation
CLUTCH - FIXED DISPLACEMENT A/C COMPRESSOR NOTE: Typical A/C compressor and clutch assembly shown in illustrations. Fig. 214: Clutch Coil & Snap Ring 1. Align the dowel pin on the bac ...

Description, Standard procedure
DESCRIPTION Fig. 331: Identifying Timing Drive System Components The timing drive system has been designed to provide quiet performance and reliability to support a NON freewheeling engine. The ...

Removal, Installation
REMOVAL REMOVAL - NGC CONTROLLER Fig. 39: Remove/Install PCM NOTE: USE THE SCAN TOOL TO REPROGRAM THE NEW POWERTRAIN CONTROL MODULE (PCM) WITH THE VEHICLES ORIGINAL IDENTIFICATION NUMBER ( ...